Pilot Report Details

Pilot Report - UAL7643 (March 17, 2016)

Virtual United Flight UAL7643

Victor Martinez United States
Departure: OMDB
Arrival: NZAA
Aircraft: A350-941 (A359)
Submitted: March 17, 2016
Flight Time: 15.52
Landing Rate: -255 FPM
Fuel Used: 290,587 LBS
Distance: 7,676 NM
Status: Accepted

ACARS Flight Log

smartCARS version 2.1.21.0, 2016/3/17 UTC
[23:46:44] Preflight started, flying offline
[23:46:44] Flying CS 777-200LR Captain Paint2
[23:46:44] Engine 1 is on
[23:46:44] Engine 2 is on
[23:50:32] Pushing back with 318569 lb of fuel
[23:52:57] Flaps set to position 2
[23:54:34] Taxiing to runway
[00:00:22] Taking off
[00:00:55] Climbing, pitch: 16, roll: 1 degrees left, 171 kts
[00:01:02] Gear lever raised at 305 ft at 177 kts
[00:01:32] Flaps set to position 1 at 1610 ft at 198 kts
[00:02:02] Flaps set to position 0 at 2619 ft at 219 kts
[00:24:22] Cruising at 41000ft, pitch: 5, 499 kts
[01:18:50] Sim paused
[01:39:02] Sim unpaused
[11:18:17] Sim paused
[19:41:46] Sim unpaused
[23:22:58] Fuel quantity increased to 82850 lb from 44242 lb
[00:06:15] Sim paused
[00:08:30] Sim unpaused
[00:09:56] Descending
[00:29:38] Approaching
[00:33:38] Flaps set to position 1 at 4103 ft at 210 kts
[00:33:48] Flaps set to position 2 at 3931 ft at 210 kts
[00:34:30] Gear lever lowered at 3463 ft at 205 kts
[00:34:33] Flaps set to position 3 at 3420 ft at 202 kts
[00:34:54] Flaps set to position 4 at 2672 ft at 193 kts
[00:35:23] Flaps set to position 5 at 2613 ft at 201 kts
[00:35:30] Final approach, 206 kts
[00:36:05] Flaps set to position 6 at 2177 ft at 168 kts
[00:38:47] Touched down at -255 fpm, gear lever: down, pitch: 4, roll: 1 degrees left, 134 kts
[00:39:13] Landed in 4238 ft, fuel: 27994 lb, weight: 396415 lb
[00:39:13] Taxiing to gate
[00:39:18] The flight may now be ended
[00:39:18] Taxi time was less than 15 seconds
[00:39:18] Arrived, flight duration: 15:52

Comments

  • Victor Martinez writes: “I did not increase fuel, I transfered from right tank into left tank because it was running out of gas manually. I don't know how to do it automatically with this add-on. Thank you.”